KUPC LLP`s mobile power source transformer with integrated P256 6 channel, automatic controller built into the power source, eliminating the additional process of on-site setup.
The P256 module gives the technician both the option of automatic profile control for post weld heat treatment, and also manual set point control for each channel used in pre-heating.
This unit is housed in the same casing as the standard 25KVA/ 50KVA/ 65KVA Thermotech mobile power source transformer, and also be used both in a workshop and on site.
The rear of the unit features 2X110V auxiliary devices, programming devices, and thermocouple attachments units. The transformer can be deliverd with 48 volt or 60 volt output.
